It’s easy to make a stylish DIY polycarbonate tray in under five minutes. All you need is an polycarbonate clear solid sheet cut to size by just polycarbonate and a pair of handles.
You’ll need:
A pair of handles of your choice
A power screwdriver
Self-adhesive baize or felt
Masking tape
Step 1: Mark and drill the holes
Apply a piece of masking tape about 3/4in from the edge of the polycarbonate sheet. Measure the distance between the screw holes on the handles and mark this on the piece of masking tape. In our example, there’s a distance of 7in between the holes for the screws. Using a small size drill bit, drill two holes in the polycarbonate sheet.
Step 2: Fixing the handles
Remove the masking tape and apply it to the other side so that you don’t have to measure the distance between the holes again. Drill two more holes, then place the screws into position from below and place the handles on them.
Step 3: Finishing the DIY polycarbonate tray
Turn the polycarbonate sheet over and screw the screws into the handles so that they are securely attached. You can also stick self-adhesive baize to the screw heads, which will prevent your table from getting scratched.
Your easy DIY clear solid polycarbonate tray is now ready!
